Electrolux 5995421640 Start-up

Start-up

Once installation and leveling is complete, the unit is ready for initial start-up and

operation. Your unit is shipped in the OFF position, however, you may turn it ON/

OFF using the cycle selector switch located in the access panel above the grille

(see Figure 26).

1Plug the appliance cord into a 115V polarized and

grounded electrical outlet.

2Open the water supply valve in the main water source.

3Place the cycle selector switch in the ON position. The

water fill valve will energize and fill the water reservoir.

The water fill valve shuts off after 180 seconds. The

compressor begins to operate and water flows over the

evaporator assembly (ice cube tray).

4Upon initial start-up, water flow over the evaporator may

be uneven. This may cause uneven sized cubes or

water spilling into the ice storage bin. This is a normal

situation and will correct itself within the first 24 hours of

operation. After the initial start-up period, the water will

cascade evenly over the evaporator.

IMPORIMPOR

It is possible that dirt or scale will dislodge in the water line. Always throw away all ice

cubes made during the first two to three hours of operation.

Figure 26

CYCLE

SELECTORSWITCH