What to do, if, Stances | Electrolux 60820 guide

Operating Instructions

7.Put the flat filter back in the base of

the washing compartment

8.Place the coarse/fine filter in the

microfilter and press together.

9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the wash- ing compartment.

1	The dishwasher must not be used
	without filters under any circum-

stances.

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

29

Image 29

Electrolux 60820 manual What to do, if, Stances

Contents

Favorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the appliance Contents What to do, if Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety General Safety Correct Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old Appliances Appliance Features and Control Panel Multi-Display can display Control Panel Prior to using for the first time Your area Adjusting the Water SoftenerSpecial salt Electronic adjustment Fill with dishwasher salt Filling with Salt for the Water SoftenerUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwise There are two ways to add rinse aid Switching Rinse Aid Supply On and OffRinse Aid Fully open the rinse aid compartment lid Filling with Rinse Aid Daily Use Adjusting Rinse Aid Dosing Not be washed in the dishwasher Loading Cutlery and Dishes Tioned horizontally in the upper basket Loading CutleryPlace knives, small spoons and small Forks in the cutlery tray Loading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Fill with detergent Filling with Detergent Automatic Wash Programmes Concentrated DetergentDetergent tablets Soiling Selecting the Wash Programme Programme Table Start the Wash Programme Changing/Interrupting/CancellingWash Programme Changing the wash programme Cancelling the wash programme Setting or Changing the Delay Start TimerDishwasher is switched on again Changing the delay start Load Sensing Sensor Logic Switching Off the DishwasherEmptying the Dishwasher Immediately after the end of the programme Cleaning the Filter Care and Cleaning Stances What to do, if Symptom Possible Cause Solution Error messages Wash results are not satisfactory There are problems with the operation of the dish- washerDishes are still dirty Wrong wash programme was selected Dishes are wet and dull Technical DataRinse aid was not used Rinse aid container is empty Lower rinse aid dosing Lower basket with cutlery basket Sample loading arrangementsUpper basket without cutlery tray See enclosed installation instructions Installing the DishwasherBuilt-Under Dishwasher Free-Standing Appliances Work surface must be re-mounted Plinth on free-standing appliances is not adjustable Water Connection Connecting the DishwasherPermitted water pressure Connect the inlet hose Please take care when installing the water inlet hose Water inlet hose with safety valve Water drain Appliance is automatically pumped out Leak Prevention System Changing a fuse Electrical Connection Connections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG