Electrolux 60820 manual Error messages, Symptom Possible Cause Solution

Operating Instructions

...Error messages

•If fault code (2 is displayed on the multi-display or the WATER indi- cator is illuminated, you can probably rectify the fault yourself. After rectifying a (2 fault and a fault related to the WATER indica- tor, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, contact AEG Sevice Force.

•For all other faults, please contact AEG Sevice Force, stating the fault code.

Symptom	Possible Cause	Solution
The programme indica-	Tap is blocked or furred with	Clean tap.
tor for the selected	lime-scale.
programme is flashing	The filter (where present) in
and the WATER indica-		Clean the filter in the
tor is illuminated:	the threaded hose fitting is	threaded hose fitting.
	blocked.
there is no water run-
ning into the dish-	The water inlet hose is not	Check hose installation.
washer.	correctly laid.
Fault code (2 is dis-	The sink outlet is blocked.	Clean the sink outlet.
played on the multi-
display.
The programme indica-	The water drain hose is not	Check hose installation.
tor for the selected	correctly laid.
wash programme is
flashing.
Fault code (3 is dis-	The leak prevention system	Close the tap and contact
played on the multi-		your local AEG Sevice Force
	has been triggered.
display.		Centre.
	The FILTER indicator is only
	intended to remind you to
	check the filter in the dish-
The FILTER indicator is	washer from time to time	The indicator goes out auto-
illuminated.	and, if necessary, to clean it.	matically on the start of the
	It illuminates at regular	next wash programme.
	intervals, independent of the
	amount of soiling of the fil-
	ter.

30