Electrolux 62610 manual Remove the transit bar

Problem	Possible cause	Remedy
	The transit bar has not been	Remove the transit bar.
	removed.
The washing machine	The screw feet are not cor-	Adjust the feet as described
		in the installation and con-
vibrates when operating	rectly adjusted.
		nection instructions.
or is not stable.
	There is very little washing	Operation is not affected by
	in the drum (e.g., just one
		this.
	bathrobe).
	Screw connection on the in-	Screw the inlet hose on
	let hose is leaking.	tightly.
	Drain hose is leaking.	Replace drain hose.
Water is running out	Drain pump cover is not	Close the cover properly.
from under the washing	closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	Emergency drain hose is	Close off emergency drain
	leaking.	hose properly.
Washing water is foam-		Follow the manufacturer's
ing excessively. At the	Probably too much deter-
		instructions exactly when
end of the washing cy-	gent has been used.
		measuring out detergent.
cle, the spin stops.
	Kink in drain hose.	Straighten the hose.
E20 appears.	Maximum pumping height	Please contact the Customer
	of 1m exceeded.	Care Department.
indicator (END)		Switch off the appliance.
flashes 2x, at the same
time an acoustic signal	Drain pump is blocked.	Disconnect the power plug.
sounds 2x.		Clean the drain pump. Re-
(Problems with water		move foreign bodies from
outflow)		the pump housing.
	For sink spigot connections:	Clean the sink spigot.
	The sink spigot is blocked.
Conditioner not rinsed	Conditioner insert in the	Clean the detergent drawer,
in, w compartment for	compartment for additives
		insert the conditioner insert
additives is filled with	is not correctly attached or
		firmly.
water.	is blocked.

19