Electrolux 65011 VI user manual What to do if…, appears in the digital display

30What to do if…

	Fault code and malfunction		Possible cause and solution
•	continuous flashing of the light of the run-	•	The water tap is blocked or furred with lime-
	ning programme		scale.
• point-shaped optical signal is flashing			Clean the water tap.
•	appears in the digital display.	•	The water tap is turned off. Turn the water tap
•	intermitted audible signal		on.
The dishwasher does not fill with water.		• The filter (where present) in the threaded hose
			fitting at the water inlet valve is blocked.
			Clean the filter in the threaded hose.
		•	The water inlet hose has not been correctly
			laid or it is bent or squashed.
			Check the water drain hose connection.
•	continuous flashing of the light of the run-	•	The sink spigot is blocked.
	ning programme		Clean out the sink spigot.
•	point-shaped optical signal is flashing
		•	The water drain hose has not been correctly
•
	appears in the digital display.		laid or it is bent or squashed.
•	intermitted audible signal		Check the water drain hose connection.
The dishwasher will not drain.
•	continuous flashing of the light of the run-	•	Close the water tap and contact your local
	ning programme		Service Force Centre.

•point-shaped optical signal is flashing

• appears in the digital display.

•intermitted audible signal

Anti-flood device is activated.

The programme does not start.	•	The dishwasher’s door has not been properly
		closed. Close the door.
	•	The main plug is not plugged in. Insert the
		main plug.
	•	The fuse has blown out in the household fuse
		box.
		Replace the fuse.
	•	Delay start has been set.
		If dishes are to be washed immediately, cancel
		the delay start.

The flashing of the point-shaped optical signal on the floor beneath the dishwsher's door will not be visible if the appliance has been installed higher up with a furniture door mounted flush.