What to do if… 31
Once these checks have been carried out, switch on the appliance: the programme will continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher door.
So that you always have these numbers at hand, we recommend you to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not clean | • | The wrong washing programme has been se- |
|
| lected. |
| • | The dishes are arranged in such a way as to |
|
| stop water reaching all parts of the surface. |
|
| The baskets must not be overloaded. |
| • | The spray arms do not rotate freely due to |
|
| incorrect arrangement of the load. |
| • | The filters in the base of the washing com- |
|
| partment are dirty or incorrectly positioned. |
| • | Too little or no detergent has been used. |
| • | Where there are limescales deposits on the |
|
| dishes; the salt container is empty or the in- |
|
| correct level of the water softener has been |
|
| set. |
| • | The drain hose connection is not correct. |
| • | The salt container cap is not properly closed. |
The dishes are wet and dull | • | Rinse aid was not used. |
| • | The rinse aid dispenser is empty. |
There are streaks, milky spots or a bluish coating | • | Decrease rinse aid dosing. |
on glasses and dishes |
|
|
Water drops have dries onto glasses and dishes | • | Increase rinse aid dosing. |
| • | The detergent may be the cause. Contact the |
|
| detergent manufacturer’s consumer care line. |
|
|
|