Installation Instructions |
|
25 | |
|
|
Sticking the seal in the rabbet
•Clean the rabbet in the work surface.
•Stick the
–Cut the sealing tape into four pieces relating to the length of the edges of the rabbet.
–For the four corners of the rabbet the ends of the sealing tapes must be cut into mitres. Do not stick the ends over one another.
–Stick the sealing tape flush into the corner of the rabbet, so that no silicon compound can get under the glass ceramic when grouting.
–Don’t stretch the tapes when sticking them on.
•If installing flush with the work surface, use sealing tape with dimensions 10x2mm.
Sticking on the seal
•Clean the worktop around the
•Stick the
•If installing proud of the work surface, use the sealing tape with dimensions 6x2mm.