32
Malfunction Possible cause Remedy
1 short warning tone,
continuously repeated,
can be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing:
the WATER control indi-
cator lights up:
fault code Å10 is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or faulty.
Check the water tap and
have it repaired if necessary.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
dishwasher compartment
are blocked.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Water inlet hose
has not been correctly posi-
tioned.
Check the position of the
hose.
2 short warning tones,
continuously repeated,
can be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing,
fault code Å20 is dis-
played in the multi-dis-
play. (Problems with water
outflow)
The sink outlet is blocked. Clean out sink outlet.
Water drain hose
has not been correctly posi-
tioned.
Check the position of the
hose.
3 short warning tones,
continuously repeated,
can be heard,
Fault code Å30 is dis-
played in the multi-dis-
play.
The anti-flood system has
been triggered.
First shut off the water tap,
then switch off the appli-
ance and contact the Cus-
tomer Care Department.
1 long warning tone can
be heard,
The SPRAY ARM control
indicator is lit.
The upper basket spray arm
is jammed.
Open the door carefully
Hot steam may escape when
the door is opened. There is
a risk of scalding. Arrange
the dishes and cutlery in the
baskets so that the spray
arm above can rotate freely.
Close the dishwasher door.
The DOOR control indica-
tor is lit.
The door of the dishwasher
is open. Close the dishwasher door.