Electrolux AH 360-120 manual Important Before marking the securing holes

15	Proceed as follows:
	Important: Before marking the securing holes,
	make sure that no electricity or water lines or
300	other lines are laid at the drilling points in the wall.
	Important: There are two handles on top of the
310	hood. Only carry the hood using these handles. Do
	not lift the hood by the stainless steel side panels
230
	or the aluminium front panel.
76,5
270	– From the bottom edge of the hood, mark a center
518,5	line on the wall.
120	– With the aid of the drilling template, mark the
960
min. 650 electric	positions of the screws on the wall. Mark the
min. 750 gas	contour of the hook-in area. This will make it
	easier to hook in the hood (Fig. 16).
	– Pay attention to the minimum clearance of 650 mm
	for electric cookers and 750 mm for gas cookers.
Fig. 16	The bottom edge of the template corresponds to
	the bottom from edge of the hood.
	– Using the drilling template, drill the 6 holes for
	the hood (area I of the drilling template) and the
	two holes for suspending the chimney (area II of
	the drilling template). In the top two securing
	holes for the hood, fix the two hooks d with the
	countersunk screws c. Fit the included dowels a
	in the other drill holes.
	Note: Pay attention to any special accessories that
	you may have to fit.
	– Screw on the retaining bracket for the chimney
	paneling.
	– Detach the grease filters.
	– Hang the hood on the two hooks. Adjust the
	suspended element with the recessed head
	screw and align the hood using a spirit level
	(Fig. 17).
Fig. 17
14