Installation
Positioning the Appliance (Fig. 1)
-Note A: The appliance is designed to be flush fitted with 2mm clearance at each side to allow for it to be pulled forward for cleaning etc.
-Note B: The hotplate side trims should be flush with the cabinets and must not be below. Adjustable levelling feet at the front and rear are provided on the base of the appliance. Adjustment is obtained by rotating in or out, the feet at the front or rear of the appliance from the underside of the appliance, with the drawer removed.
A spirit level should be placed on a cake tray on one of the shelves to confirm that the appliance is correctly levelled. The levelling feet fitted to the appliance will achieve a height to hotplate trims of
-Note C: If the appliance is fitted next to a side wall or cabinets above height of the hotplate trims, then a gap of 115 mm is required.
Curtains must not be fitted immediately behind the cooker or within 115 mm of the sides of the cooker.
-Note D: Any wall cabinet or extractor must not be lower than 780mm above hotplate level.
-Note E: Wall cabinets may be fitted in line with the sides of the base units, providing that the lower edge of the wall cabinet is a minimum of 420mm above the worktop.
Feet Assembly
Before installing the cooker, it is necessary to assemble the supplied feet.
1.Remove the hob pan supports, the burner caps and crowns and the oven accessories.
2.Carefully lean the cooker on its back (Fig. 2), paying attention not to cause any damage.
3.Adjust the feet height by unscrewing the bottom part of each foot, until you obtain the required height (height can be adjusted from 850 to 880 mm).
4.Insert the feet into the relevant holes indicated in fig. 2.
5.Lift the cooker in vertical position. Replace the crowns, the burner caps, the hob pan supports and the oven accessories.
6.If necessary, adjust the cooker horizontal levelling by turning the bottom part of the feet, until the appliance is completely stable.
Splash back Assembly
A splash back is supplied with the appliance. This is meant to be fitted on the rear edge of the cooker’s hob. The splash back is found in the oven cavity.
1.Carefully clean the hob top.
2.Take the splash back out of the envelope and remove the protective film.
3.Insert the splash back into the proper hinges in the rear part of the hob (Fig. 3).
|
| D |
|
|
| C |
| 780 | E |
| 115 | 420 | ||
|
| |||
|
|
|
| |
|
| B |
|
|
Fig. 1 |
|
|
| A |
FO 2599 |
|
|
|
The appliance must be installed in accordance to the type X (standard EN
Therefore the appliance can not be installed beside furniture higher than the cooker worktop.
This cooker must only be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.
Fig. 2 | FO 2283 |
Fig. 3 | FO 2376 |
| |
| 19 |
