Conversion from Natural to LPG Gas
IMPORTANT
The replacement/conversion of the gas hob should only be undertaken by a CORGI registered engineer.
It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. The gas rate is adjusted to suit.
Method
•Ensure that the gas taps are in the 'OFF' position
•Isolate the hob from the electricity supply
•Remove all pan supports, burner caps, rings, crowns and control knobs.
•With the aid of a 7mm box spanner the burner injectors can then be unscrewed and replaced by the appropriate LPG injectors.
TO ADJUST THE GAS RATE
With the aid of a thin bladed screwdriver undo the by pass screw about 1/4 of a turn (45°). Upon completion stick the replacement rating plate near the gas supply pipe.
Minimum level adjustment of gas oven burner
After setting the oven on maximum temperature with door closed for about 10 minutes, turn the knob on minimum. To reach the thermostat
–take out the knobs;
–remove the front panel;
–in case of conversion from natural gas to LPG, tightly screw the
–to convert from LPG to natural gas, unscrew the by- pass screw, until a regular small flame is reached.
–finally check that turning quickly the tap from maximum position to minimum position, the flame does not go out;
–reassemble the front panel and the knobs.
The oven burner does not need any primary air regulation.
Replacement of gas oven burner nozzle
To replace the gas oven nozzle, follow this procedure:
a)remove the bottom of the oven;
b)undo screw 1 and take the oven burner out;
c)with a socket spanner 7 unscrew and remove the nozzle, situated in the bottom of the oven, and replace it with the proper one (see Table on page 18);
d)reassemble the burner following the same procedure backwards.
FO 1061
23
