Electrolux D2100-5 manual Choice of Electrical Connection, Preparing Cabinet for Fitting of Oven

CHOICE OF ELECTRICAL CONNECTION

•There are three possible ways to connect your

appliance. In each case the appliance should be operated using at least 6mm2 twin core and earth PVC insulated. Please choose from the most appropriate after reading the different methods:-

a)By connecting the appliance to a cooker point (having a double pole isolating switch with at least 3mm contact separation in all poles and neutral) and protected with a fuse or miniature circuit breaker at your mains fuse box.

Subject to Regional Electricity Companies regulations if you wish to connect the oven and hob to the power supply you may use one of the following two methods:-

b)By connecting the appliance together with a hob directly to a cooker point(s). Having a double pole isolating switch with at least 3mm contact separation in all poles and neutral.

c)If you wish to connect an oven and a hob to a cooker point you can by connecting the oven and hob separately to the cooker point. Oven and hob units should be separately connected to a cooker point. See Fig. 2.

NOTE: It is good practice to :

•Fit an Earth Leakage Circuit Breaker to your house wiring.

•Wire your appliance to the latest IEE regulations.

PREPARING CABINET FOR FITTING OF OVEN

•Make sure that the cabinet is the correct size for the appliance to be fitted (Ref. Fig. 3).

•If the size is between 565-570mm, then the cabinet should be modified so that at the screw fixing points the recommended dimension of at least 560-565mm is maintained. The modification should ideally be localised to ensure that after screw fitment the oven is securely fixed into position.

•The cabinet must be stable and level by firmly securing it to the wall or floor. If necessary, make arrangements to ensure the shelf upon which the oven will rest is level.

•When the appliance is installed ensure a minimum gap of 2mm is maintained between the trim on the bottom edge of the appliance, and any corresponding door / panel underneath.

Fig. 2

30