Installation 15
•Put the two (2) cabinet glide assemblies, and shims if necessary, as shown on the inside surfaces of the cabinet. Position them 3 1/2” (9.0cm) from the front edge of the cutout opening.
4” (100mm) Cabinet Back Cutout for
Air Circulation
• | Insert the screws in |
|
|
| the holes of the glides | Cabinet | Rear |
| without tightening them |
| |
|
|
| |
| completely. |
|
|
3 1/2” |
(8.9cm) |
•Make sure the outside distance between the fixing angles is 22 1/8” (56.2cm) and that the glides are level. Change the number of shims or adjust the fixing angles as necessary.
3 9/16”
(9.0cm)
18”
(45.7cm)
Cabinet | Front |
|
IMPORTANT: Make sure that the glides are level.
•Tighten all of the screws.
•Make sure that the power cord and water feed line can be fed freely through the back wall.
•In order to avoid overheating the coffee maker, make an opening of at least 3 15/16” (10.0cm) at the back of the cabinet to allow air to circulate.
