Electrolux EDB 876 Installation Instructions, Things You Need To Know, Warnings, Things To Note

Models: EDB 876

1 48
Download 48 pages 24.36 Kb
Page 38
Image 38
INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

THINGS YOU NEED TO KNOW

THINGS YOU NEED TO KNOW WARNINGS:

In the interest of safety this appliance must be installed and / or serviced by a competent person (Corgi registered). Safety may be impaired if installation is not carried out in accordance with these instructions.

This appliance must be earthed.

Do not remove the screws from the earth tab extending from the oven mains terminal block (Fig. 1).

Before connecting the appliance make sure that the gas type and the voltage of your electricity supply is the same as that indicated on the rating plate. The rating plate can be seen on the rear panel of the appliance.

Do not alter the electrical circuitry of this appliance.

NOTE: HOUSE CIRCUIT

Earth leakage / continuity tests must be carried out before the appliance is connected to the mains supply and re-checked after fitting.

NOTE: It is good practice to:

Fit an Earth Leakage Circuit Breaker to your house wiring.

Wire your appliance to the latest IEE regulations.

THINGS TO NOTE

LOCATION OF APPLIANCE

The appliance may be located in a kitchen, a kitchen/diner or bedsitting room, but not located in a bathroom or shower room.

L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or other vessel.

It is essential that there is a minimum clearance of 2mm between the top surface of the appliance and the inside top of the cabinet.

This appliance is designed to be fitted between cabinets with the recommended dimensions as shown in Figs. 2 and 3.

Fig.1

Fig.2

Fig.3

38

Page 38
Image 38
Electrolux EDB 876 manual Installation Instructions, Things You Need To Know, Warnings, Note House Circuit, Things To Note