Installation
Wall unit mounting - Fig. 8
•Put the template onto the wall (1) and drill two Ø12mm holes (2).
•Fit two hooks (3) on the drilled holes.
•Remove the metal filters (4) and hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5).
•Depending on the model, mark 2 or 4 points (6). Remove the hood and drill 2 or 4 Ø8mm holes on the marked points. Fit 2 or 4 Ø8mm wall dowels, Hang again the hood and fix the hood definitively with 2 or 4 screws 5X45 (7).
•Fix the chimney support (8) with two screws 5 x 45 mm and two wall dowels on the wall close to the ceiling.
•For the extraction version: Fit the connection ring (S) on the top of the hood with two screws Ø 3,5 x 6,5 mm (9S) then fit an axhausting pipe long enough to reach the outside (10S).
For the recirculation version: Fix definitively the deflector (K) on the top of the hood with two screws Ø 3,5 x 6,5 mm (9K).
•Prepare the electric connection (11) (see relative chapter).
•Fit the chimney (12) and fix it on
| the chimney support with two |
| 8 | ||
| screws 3,0 x 9 mm (13). |
| 13 | ||
| The lower part of the chimney |
|
| ||
| must be slided down and inserted | 13 |
| ||
| on the housing on the upper part of |
| |||
|
|
| |||
| the hood (14). |
| 11 | 12 | |
• | Fit the two grids (15) | on both | |||
|
| ||||
sides of the chimney.
15
6 | 6 |
|
|
|
|
|
|
|
| 15 | 14 | 14 | |
|
|
|
| |||
|
|
| 7 |
| ||
3 | 2 | 3 | 7 |
|
| |
6 | 4 |
|
|
| ||
|
|
|
| |||
6 |
| 4 |
|
| 7 |
|
|
|
|
|
| ||
1 | 7 |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| 4 |
|
|
| 4 |
|
|
|
|
5 |
|
|
|
| 10S |
|
| 9K | 9K |
|
|
|
|
|
|
|
|
|
| |
K |
| 39 |
|
| S | 9S |
|
| 9K | 9K |
| 9S |
|
|
|
|
|
| ||
|
|
|
|
|
| |
|
| 9S |
| 9K | 9K |
|
|
|
|
|
|
|
Fig. 8
