Electrolux EHGT326X manual Adaptation to different types of gas, Replacing the burner injectors

Adaptation to different types of gas

Replacing the burner injectors

1.Remove the pan supports.

2.Remove the burner's caps and crowns.

3.With a socket spanner 7 unscrew and remove the injectors (Fig. 6), and replace them with the ones required for the type of gas in use (see Table 2).

4.Reassemble the parts, following the same procedure backwards.

5.Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance.

Should the feeding gas pressure be different or variable compared with the required pressure, an appropriate pressure adjuster must be fitted on the gas supply pipe, in compliance with the rules in force.

Adjusting the minimum level

To adjust the minimum level of the burners, proceed as follows:

1.Light the burner.

2.Turn the knob on the minimum position.

3.Remove the knob.

4.With a thin screwdriver, adjust the by-pass screw (see Fig. 7). If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained.

5.Finally check the flame does not go out when quickly turning the knob from the maximum position to the minimum position.

This procedure can easily be carried out, anyhow the hob has been positioned or built in the working top.

Table 2 : injectors

Fig. 6 FO 0392

Fig. 7

By-pass screw

Table 1 : BY-pass diameters

Burner	Ø By-pass
	in 1/100
	of mm.
Auxiliary	28
Rapid	42

BURNER	NORMAL	REDUCED			NORMAL
	POWER	POWER			POWER
	kW	kW	NATURALGAS		LPG G30/G31
			G20 20 mbar			28-30 mbar
			inj. 1/100	m3/h	inj. 1/100	g/h - G30	g/h - G31
Auxiliary (small)	1,0	0,33	70	0,095	50	72		71
	Natural gas :
Rapid (big)	3,0	0,65	119	0,286	86	203		200
	LPG : 2,8

8