NOTES
37
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pr oceed
as follows:
The wire which is GREEN and YELLOW must be
connected to the terminal in the plug which is m arked
with the letter ‘E’ or by the earth symbol
or coloured GREEN or GREEN and YELLOW.
The wire which is coloured BLUE must be connected to
the terminal which is marked with the letter ‘N’ or
coloured BLACK.
The wire which is coloured BROWN must be connec ted
to the terminal which is marked with the letter ‘L’ or
coloured RED.
FIT A 3 AMP FUSE TO THE PLUG FUSE HOLDER
· Turn on Gas and Electric supplies.
· Carry out a gas tightness test.
· Switch off electric supply.
INSTALLATION BETWEEN CABINETS
· Lift the appliance into the cabinet making sure the
hose and the cable are not trapped. Push the
appliance as far back as it will go.
· N.B. Two people will be required to carry out the
lifting procedure.
Warning: Do Not attempt to lift this appliance by the
handle(s).
· Centralise and fix the appliance to the undersid e of
the worktop using the two stability screws provided,
in the position indicated in Fig.10.
· Refit the plinth board.
Place the top trim with the cork washers uppermost
flush with the edge of the worksurface (see Fig.11)
and screw into the position using the screws
supplied with the appliance.
Switch on the appliance then refer to the operating
instructions in the following pages.
· Carry out a gas tightness test.
· Ensure the owner is given these operating
instructions.
CHECKING THE ELECTRICAL
CONNECTIONS
· Confirm the appliance is correctly connected by
switching on and observing the various oven
functions.
· The electronic timer will flash on and off.
NOTE: HOUSE CIRCUIT
Earth leakage / continuity tests must be carry out before
the appliance is connected to the mains supply and re-
checked after fitting.
INSTALLATION INSTRUCTIONS
Fig. 11.
Fi
g
. 10