Electrolux ERN 1673 manual Technical specifications, Installation, Positioning

Models: ERN 1673

1 20
Download 20 pages 53.64 Kb
Page 11
Image 11
Technical specifications

Technical specifications

 

ERN 1672

ERN 2372

POWER SUPPLY VOLTAGE AND FREQUENCY

220-240 V / 50 Hz

220-240 V / 50 Hz

TOTAL POWER ABSORBED

100 W

140 W

AVERAGE DAILY UNITS ELECTRICITY (*)

0,49 kWh

0,44 kWh

GROSS CAPACITY

158 l

230 l

NET CAPACITY

154 l

228 l

(*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.

Installation

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under ÒDoor reversalÓ.

Positioning

The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each climate classification.

SN

+10¡C

to

+32¡C

ST

+18¡C

to

+38¡C

The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator or in a very cold room e.g. an outhouse. If these temperatures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.

For building-in and door reversal instructions please refer to the relevant instructions on the following pages.

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

11

Page 11
Image 11
Electrolux ERN 1673 manual Technical specifications, Installation, Positioning