What to do if...

Remedying small malfunc- tions

If the acoustic signal is activated, warning tones sound if there are faults.

If one of the following fault codes is displayed in the multi-display during operation:

Fault codeÅ 10 (Problems with water inlet),

Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

Abort the dishwashing cycle.

Switch the appliance off and on again.

Re-set the dishwashing cycle.

If the fault is displayed again, please contact your lo- cal Service Force Centre and inform them of the fault code.

Malfunction

 

Possible cause

Remedy

 

 

 

 

 

 

Water tap is blocked with limescale

Check the tap and have it repaired, if

 

 

or is faulty.

necessary.

 

 

 

 

 

 

The tap is turned off.

Turn on the tap.

1 short warning tone, continu-

 

 

The filter (where present) in the

Clean the filter in the threaded hose

ously repeated, can be heard,

threaded hose fitting on the tap is

fitting.

the cycle indicator for the selected

blocked.

 

wash program is flashing:

 

 

 

 

 

Cancel the dishwashing cycle (see

the control indicator

lights

 

 

chapter: Starting a dishwashing cy-

up:

 

 

 

Filters in the base of the washing

cle),

fault code Å 10 is displayed in the

clean filters (see chapter: Cleaning

multi-display:

 

compartment are blocked.

 

the filters),

(Problems with water inlet)

 

 

then start the dishwashing cycle

 

 

 

 

 

 

again.

 

 

 

 

 

 

Water supply hose has not been

Check the position of the hose.

 

 

correctly positioned.

 

 

 

 

 

 

2 short warning tones, continu-

The sink outlet is blocked.

Clean the siphon.

ously repeated, can be heard,

 

 

 

 

the cycle indicator for the selected

 

 

dishwashing cycle is flashing,

Water drain hose has not been cor-

Check the position of the hose.

fault code Å 20 is displayed in the

rectly positioned.

 

multi-display. (Problems with wa-

 

 

ter outflow)

 

 

 

 

 

 

3 short warning tones, continu-

 

First shut off the water tap, then

ously repeated, can be heard,

The anti-flood system has been

switch off the appliance and contact

Fault code Å 30 is displayed in

triggered.

the Customer Care Department.

the multi-display.

 

 

 

 

 

 

 

 

 

26

Page 26
Image 26
Electrolux ESL 6251 manual What to do if, Remedying small malfunc- tions, Malfunction Possible cause Remedy