Wire receptacle Nema type 14-30R | Electrolux 137018200 A, EWMED65H

Installation Instructions 13

Electrical connection (non-Canada) - 4 wire cord

4-wire receptacle

(NEMA type 14-30R)

WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before servicing could result in personal injury or even death.

1.Turn off power supply to outlet.

2.Remove the screw securing the terminal block access cover in the lower corner on the back of the dryer.

3.Install a UL-approved strain relief according to the power cord/strain relief manufacturer’s instructions in the power cord entry hole below the access panel. At this time, the strain relief should be loosely in place.

4.Thread an UNPLUGGED, UL-approved, 30 amp. power cord, NEMA 14-30 type ST or

SRDT, through the strain relief.

5.Disconnect the internal (BLACK) dryer harness ground wire from the (GREEN) ground screw next to the terminal block.

6.Attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) screw.

Tighten the screw securely.

7.Move the internal dryer harness ground (BLACK) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the screw securely.