16 electrolux |
|
|
|
|
|
Problem |
| Possible cause |
|
| The programme knob is not in |
|
| the correct position. |
|
| The delay start is set. |
|
| It is available only for models |
|
| with the Delay start. |
The appliance does not |
| The water tap is closed. |
fill with water. |
|
|
|
| The water inlet hose is dam- |
|
| aged. |
|
| The filter in the water inlet |
|
| hose is blocked . |
|
| The water tap is blocked or |
|
| there is limescale on it. |
|
| The connection of the water |
|
| inlet hose is not correct. |
|
| The water pressure is too low. |
The appliance does not |
| The water drain hose is dam- |
drain the water. |
| aged. |
|
| The filter of the drain pump is |
|
| blocked. |
|
| The connection of the water |
|
| drain hose is not correct. |
|
| A washing programme without |
|
| the drain phase is set. |
|
| The function Rinse Hold is on. |
The spin phase does |
| The spin phase is off. |
not operate. |
|
|
|
| The filter of the drain pump is |
|
| blocked. |
|
| Balance problems with the |
|
| laundry load. |
There is water on the |
| Leakages from the couplings |
floor. |
| of the water hoses. |
|
| Leakages from the drain |
|
| pump. |
|
| The water drain hose is dam- |
|
| aged. |
You cannot open the |
| The washing programme is in |
appliance door. |
| operation. |
|
| There is water in the drum. |
The appliance makes |
| Incorrect level of the appli- |
an unusual noise. |
| ance. |
|
| You did not remove the pack- |
|
| aging and/or the transit bolts. |
|
| The load is very small. |
|
|
|
Possible solution
Turn the programme knob in the correct position.
To start immediately the programme, cancel the delay start.
Open the water tap.
Make sure that the water inlet hose has no damages.
Clean the filter. Refer to 'Care and clean- ing'.
Clean the water tap.
Make sure that the connection is cor- rect.
Contact your local water authority.
Make sure that the water drain hose has no damages.
Clean the filter of the drain pump. Refer to 'Care and cleaning'.
Make sure that the connection is cor- rect.
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin phase again.
Make sure that the couplings are tight.
Make sure that the drain pump filter is tight.
Make sure that the water inlet hose has no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer to 'Installation'.
Remove the packaging and/or the trans- it bolts. Refer to 'Installation'.
Add more laundry in the drum.
