4.Install again the inlet hose. Make sure that the couplings are tight to prevent leakages.
5. Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot drain the water.
If this occurs, do steps (1) through (5) of 'To clean the drain pump'.
If necessary, clean the pump.
When you drain the water with the emer- gency drain procedure, you must activate again the drain system:
1.Put 2 litres of water in the main wash compartment of the detergent dispens- er.
electrolux 15
2.Start the programme to drain the wa- ter.
FROST PRECAUTIONS
If the appliance is installed in an area where the temperature can be less than 0 °C, re- move the remaining water from the inlet hose and the drain pump.
1.Disconnect the mains plug from the mains socket.
2.Close the water tap.
3.Remove the water inlet hose
4.Put the two ends of the inlet hose in a container and let the water flow out of the hose.
5.Empty the drain pump. Refer to the emergency drain procedure
6.When the drain pump is empty, install the inlet hose again.
Warning! Make sure that the temperature is more than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages caused by low temperatures.
TROUBLESHOOTING
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (re- fer to the table). If not, contact the service centre.
With some problems, the display shows an alarm code:
•E:00 - The appliance door is open or not closed correctly or it does not fill with wa- ter.
•E:01 - The appliance continuously fills and drains the water or it does not drain or do the spinning phase.
•E:02 - Technical malfunction, contact the service centre.
•E:03 - Technical malfunction, contact the service centre.
Warning! Deactivate the appliance before you do the checks.
Problem |
| Possible cause |
The appliance does not |
| The mains plug is not connec- |
start. |
| ted in the mains socket. |
|
| The fuse in the box fuse is |
|
| damage. |
|
| The appliance door is open. |
|
| You do not press the start but- |
|
| ton |
|
|
|
Possible solution
Put in the mains plug.
Replace the fuse.
Close the door firmly.
Press the start button.
