Problem
The appliance fills with water and drain imme- diately.
The washing results are not satisfactory.
Possible cause
The end of the drain hose is too low.
The detergent you used was not sufficient or correct.
You did not remove the stub- born stains before you wash the laundry.
Incorrect temperature was set.
Too much laundry load.
electrolux 17
Possible solution
Make sure that the drain hose is in the correct position. Refer to 'Installation'.
Increase the detergent quantity or use a different one.
Use special products to remove the stubborn stains.
Make sure that you set the correct tem- perature.
Decrease the laundry load.
After the check, activate the appliance. The programme continues from the point of inter- ruption.
If the problem occurs again, contact the service centre.
SERVICE
Refer to the information supplied with this appliance for guarantee condition and point of contact. The information to give to the service is on the rating plate.
We recommend that you write the information here:
Model | .................. |
Product number | 914 |
Serial number | .................. |
(S.N.) |
|
INSTALLATION
UNPACKING
1.Use the gloves. With a scissor cut the straps and with a cutter remove the ex- ternal film.
Do not to discard the plastic cover (A).
A
2 
1
2.Remove the polystyrene packaging materials.
