SELECT THE TIME MANAGER OPTION BY PRESSING BUTTONS 10
By pressing these buttons repeatedly, the duration of the washing cycle can be in- creased or decreased. The soil level icon will appear on the display to indicate the chosen degree of soil. This option is availa- ble only with Cotton, Synthetic and Deli- cate programmes.
electrolux 11
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro- gramme which is running, the correspond- ing green pilot light starts blinking.
Press the button again to restart the pro- gramme.
CANCELLING A PROGRAMME
Turn the selector dial to 
to cancel a pro- gramme which is running.
Soil Level
Intensive
Normal
Daily
Light
Quick
Super Quick
1)
Refresh 1)
Super Re- fresh1)
Icon
2)
2)
Type of fabric
For heavy soiled items
For normal soiled items
For daily soiled items
For slightly soiled items
For very slightly soiled items
For items used or worn for a short time
For refreshing items only
For refreshing a very few items only
You can select now a new programme.
OPENING THE DOOR
After the programme has started and through the delay time the door is locked. If for any reason, you need to open it, set firstly the machine to PAUSE by pressing the button 8.
After a few minutes it will be possible to open the door.
If the door remains locked, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door!
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to O. After a few minutes the door can be opened (pay attention to the water level and temper-
1)We recommend you to reduce the load sizes (see Washing programmes table).
2)When you select this option the relevant icon appears just for a while and then it disappears immediately.
ALTERING AN OPTION OR A RUNNING PROGRAMME
It is possible to change some options be- fore the programme carries them out . Before you make any change, you must PAUSE the appliance by pressing the but- ton 8 (if you wish to change the Time Man- ager option, you must cancel the running programme and make your selection again).
Changing a running programme is possible only by resetting it. Turn the programme se- lector dial to 
and then to the new pro- gramme position. Start the new programme by pressing the button 8 again. The wash- ing water in the tub will be not emptied out.
ature!).
After closing the door, it is necessary to se- lect the programme and options again and to press button 8.
AT THE END OF THE PROGRAMME
The machine stops automatically. Three blinking 0.00 appear on the display and the pilot light of button 8 goes off. Some acoustic signals sound.
If a programme or an option that ends with water left in the tub has been selected, the door remains locked to indicate that the water must be emptied out before opening the door.
Before you empty out the water, the drum continues to run at regular intervals until the water draining.
Follow the below instructions to empty out the water:
1.Turn the programme selector dial to O.
2.Select the draining or spinning pro- gramme.
