To deactivate the rinse aid indicator light be sure that the dishwasher is off and then proceed as follows:
1.Press INTENSIV 70° and 30 MIN programme push buttons simultaneously.
2.While keeping the programme push buttons INTENSIV 70° and 30 MIN pressed switch on the dishwasher by pressing the On/Off push button. The On/Off indicator light comes on. At the same time, the indicator lights of the INTENSIV 70° and 30 MIN push buttons start flashing.
SO417
3.Press the 30 MIN push button, the correspondent indicator light keeps flashing while the indicator light of the INTENSIV 70° push button turns off. At the same time the indicator light "end of programme" starts to flash.
SO419
4.Press the 30 MIN push button again, the "end of programme" indicator light turns off, this means that the rinse aid indicator light has been deactivated.
5.To memorise the operation, switch off the dishwasher by pressing the On/Off push button.
To reactivate the rinse aid indicator light follow the same process until the "end of programme" indicator light starts to flash.
Adjusting the dose |
|
According to the finish and drying results obtained |
|
adjust the dose of rinse aid by means of the 6 |
|
position selector (C) (position 1 minimum dosage, |
|
position 6 maximum dosage). |
|
Use the tip of a screwdriver to rotate the selector. |
|
Increase the dose if there are drops of water or |
|
lime spots on the dishes after washing. |
|
Reduce it if there are sticky whitish streaks on the |
|
dishes. |
|
BR02 | 13 |
|
