Electrolux FAVORIT 54730 manual Something not working, Symptom, Fault code, Solution

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.

The dishwasher is fitted with a number of alarm systems which can help you to quickly determine the cause of any problems such as; the dishwasher will not start or stops during operation, all push buttons are inoperative except for the On/Off push button or the indicator light of the programme underway and one or more of the phase indicator lights (washing, drying, end of programme) are flashing.

Press the On/off push button to switch off the dishwasher and carry out the following suggested corrective actions listed below.

Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is in guarantee.

Symptom	Fault code	Solution
The machine will not		●	The door has not been properly
start			closed.
		●	The plug is not properly inserted in
			the power socket.
		●	There is a power failure.
The machine does not	“washing” phase	●	Ensure the water tap is open.
fill with water	indicator light is	●	Ensure the mains water supply has
	flashing		not been cut off.
		●	The inlet hose may be squashed or
			bent. Reposition the hose.
		●	The inlet hose may be blocked. Switch
			off the water supply and clean the
			filter.
The dishwasher will	“drying” phase	●	The drain hose may be squashed or
not drain	indicator light is		bent. Reposition the hose.
	flashing	●	The sink may be blocked. Clear any
			blockages.
		●	The drain hose extension is not
			correct. Follow the instructions for
			connecting to the waste.
		●	There is no vent in the end of the
			drain hose.
Protection against	“drying” and “washing”	●	Close the water tap and contact the
flooding is active	phase indicator lights		Service Force Centre.
	are flashing
General	One or more phase	●	Switch off the dishwasher, switch it
	indicator lights are		back on and start the programme.
	flashing		If the alarm reappears, call the
			Service Force Centre.

27