6. To remove freezer handle: Reverse handles
while doors are off. Remove the two screws attaching the handle to the bottom of the freezer door. Swing
To reattach trim: Slide both trim locks out of trim. Insert the new adhesive trim locks contained in your literature pack. NOTE: Trim lock must be removed and installed by sliding OVER the two donut shaped areas. Install trim to handle by sliding under base of handle. Carefully align trim and press down at trim lock locations. Replace hole plug on opposite side. Use rubbing alcohol to remove any adhesive residue from old trim lock location(s).
bottom of handle away from the door
and slide handle straight up and off
of dovetail button. Remove screw and
dovetail button and install on other side, using the same holes as the nameplate. To move nameplate to other side, remove the magnetic nameplate from its frame, turn frame upside down and install in old handle holes. Insert magnetic nameplate into frame. Reverse instructions for reattaching handle. Start with handle offset away from the door. Place top of handle over dovetail button, swing handle into an upright position and push upward, locking it into place. Secure bottom of handle with screws.
7. To remove | Refrigerator Door |
refrigerator |
8.Remove door stop from bottom of freezer and refrigerator door and reinstall on opposite side.
Freezer Door |
Refrigerator Door |
handle: Remove the |
two screws attaching |
the handle to the top |
of the refrigerator |
door. Swing the top |
of handle away |
from the door and |
slide handle down |
and off of dovetail |
button. Remove |
screw and dovetail |
button and install on |
other side moving |
hole plugs from |
corresponding holes |
to the opposite side. |
Reverse instructions |
for reattaching |
handle. Start with |
handle offset away |
from the door. Place |
bottom of handle
over dovetail button,swing handle into an upright position and push downward, locking it into place. Secure top of handle with screws.
Trim Removal
In some models, the refrigerator door has a full length trim piece which continues from the bottom of the handle to the bottom of the door. The top of the trim fits around the base of the handle. An adhesive "trim lock" is positioned about halfway down. The bottom of the trim is held in place by either an adhesive trim lock, or a trim lock with two prongs inserted into a hole on the face of the door. Remove the trim by gently pulling the trim lock areas out and away from the door. When the trim is free from the door, gently pull the trim down and away from the base of the handle.
9. If your |
| |
refrigerator does |
| |
not have a Toe |
| |
Grille, use a putty |
| |
knife to remove |
| |
the plastic plug |
| |
(not shown) from |
| |
front of base and |
| |
reinstall in the |
| |
opposite set of |
| |
lower hinge holes. | or | |
Assemble lower | ||
| ||
hinge to cabinet. |
| |
Install hinge pin in |
| |
opposite hinge |
| |
hole from which it |
| |
was removed. |
| |
Install the washer |
| |
(some models) on |
| |
the lower hinge |
| |
pin and insert |
| |
hinge screws, but |
|
do not tighten. Hinges will have to remain loose against cabinet to align door.
10.Turn center hinge upside down and secure to cabinet as shown, using the screws
which are in the new holes. Install refrigerator door on lower hinge pin. Align door with edge of cabinet. Hold the door on front of cabinet.
11