Refrigerator Toe Grille Assembly Instructions
NOTE: If your refrigerator has the type of Mounting Clips shown in Figure 1B below, use this procedure.
Tools Required: None
To Attach the Toe Grille to the Mounting Clips:
•With the end of the Toe Grille against the side of the Lower Hinge, align the two (2) Assembly Slots with the two (2) Mounting Clips.
•Snap the Toe Grille onto the Mounting Clips. (See Figures 1A and 1B)
NOTE: A properly mounted Toe Grille should have its edge against the Lower Hinge, and the back of the Toe Grille tight against the refrigerator base.
To Remove the Toe Grille:
•Carefully tilt the bottom edge of the Toe Grille away from the refrigerator base.
•Pull the Toe Grille toward you until it “unsnaps” from the Mounting Clips. (See Figure 2)
For Cleaning:
Hand wash in Warm Soapy Water.
The Toe Grille and Mounting Clips are NOT dishwasher safe. Placing them in the dishwasher will result in a warped and unusable Grille.
Figure 1A | Figure 1B |
| Figure 2 |
| 13 |
NOTE: If your refrigerator has the type of Mounting Clips shown in Figure 2 below, use this procedure.
Tools Required: None
To Attach the Toe Grille:
•Open the refrigerator door.
•Line up the Toe Grille Assembly over the two large holes on the front of the refrigerator base (See Figure 1).
•Push the Toe Grille Assembly into the holes until the grille snaps in place (See Figure 1).
NOTE (some models): If your refrigerator has a left hand door swing, the Toe Grille Buttons must be positioned on the left side of the keyhole slots (See Figure 2).
NOTE: Both Toe Grille Buttons must be mounted on the same side of the two keyhole slots.
NOTE: The Toe Grille should be flush with the side of the refrigerator and not interfere with the Lower Hinge.
To Remove the Toe Grille:
•Grasp the Toe Grille on each side and pull directly outward.
•The grille assembly will pop out of the holes for easy cleaning.
For Cleaning:
Hand wash in Warm Soapy Water.
Figure 1
Figure 2
