Electrolux JCZ 94181 manual Location, Electrical connection, Appliance must be earthed

46electrolux

INSTALLATION

Location

The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a contact for this purpose.

If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician.

The Manufacturer declines all responsibility if the above safety precautions are not observed.

This appliance complies with the following E.E.C. Directives:

•87/308 EEC of 2/6/87 relative to radio interference suppression.

•73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;

•89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

ATTENTION!

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

Dimensions of housing

Height 1780 mm

Depth	550 mm
Width	560 mm
	50 mm	min.
		200 cm2
		min.
		200cm2
D567

For safety reasons, minimum ventilation must be as shown in Fig.

Attention: keep ventilation openings clear of obstruction.

It is necessary that the niche is provided with a ventilation conduct having the following dimensions:

Depth	50 mm
Width	540 mm
	50
	540

3

2 1

PR01