Electrolux KO_SANTO 4085 operating instructions Prior to Initial Start-Up

Applies only to the temperature display for the refri- gerator

•When the FAST CHILL function is switched on (see also section: "Fast Chill/Fast Freeze"), "IC" is displayed in the temperature display. As long as the FAST CHILL function is switched on, no refrigerator tem- perature is indicated in the temperature display.

Applies only to the temperature display for the free- zer compartment

•If, for example, frozen goods have been partially or completely tha- wed due to a power failure, the temperature display alternately indi- cates:

–the freezer compartment temperature (ACTUAL temperature) and

–the highest temperature to which the frozen goods have warmed.

Prior to Initial Start-Up

1 Before connecting the appliance to the mains and putting it into ope- ration for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 4 hours before putting it into operation. This is necessary to allow the oil to flow back into the compressor. Otherwise the compressor may be damaged.

0Please clean the appliance interior and all accessories prior to initial start-up (see section: "Maintenance and Cleaning").

0Remove the cold accumulation block from the freezer tray.

0Place the cold accumulation block into a compartment or drawer only after the optimal storage temperature of -18°C has been reached, and allow to freeze.

0After 24 hours place the cold accumulation block at the front of the freezer tray.

0Re-freeze the thawed cold accumulation block in the same fashion, e.g. after cleaning the appliance.

818 16 35-00/7 21