30Installation
Water-stop device
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to nat- ural ageing of the hose. This fault is shown by a red sector in the window «A» . Should this occur, turn the water tap off and refer to your Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
1.Hooked over the edge of a sink using the plastic hose guide supplied with the machine.
In this case, make sure the end cannot come unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece of string or attaching it to the wall.
2. In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.
3. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
