You must select this option after you have set the programme and before you press the
button 5 .
You can cancel the delay time at any moment, before you press the button 5 .
If the button 5 has already been pressed:
•set the washing machine to PAUSE by pressing the button 5 ;
•press the button 6 once, the light relevant to the selected delay goes off;
•press the button 5 again to start the programme.
Important!
• The selected delay can be changed only after selecting the washing programme again.
• The door will be locked throughout the delay time. If you need to open the door, you
must first set the washing machine to PAUSE by pressing the button 5 and then wait
some minutes. After you have closed the door, press the button 5 again.
The DELAY START can not be selected with DRAIN programme.
Select an additional rinse
This appliance is designed for saving water. However, for people with a very delicate skin
(allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of
water (extra rinse).
Press simultaneously button 2 and 3 for some seconds: the light 7.3 comes on. This function
stays permanently on. To remove it press the same buttons again until the light 7.3 goes
off.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make
any change, you must pause the washing machine by pressing the button 5 .
Changing a running programme is possible only by resetting it . Turn the programme
selector dial to and then to the new programme position. Start the new programme by
pressing the 5 button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which is running. Now you can select
a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 5 .
After some minutes the door can be opened.
If the door remains locked, this means that the machine is already heating, that the water
level is above the bottom edge of the door. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off
by turning the selector dial to . After about some minutes the door can be opened (pay
attention to the water level and temperature!) .
10 Daily use