Electrolux LAVAMAT 62800 manual What to do if, Remedying small malfunctions

What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display dur- ing operation:

–E10 (Problems with water inlet),

–E20 (Problems with water drainage),

–E40 (door open),

please have a look at the following table.

When the fault is remedied, press the START/PAUSE button.

In the event of other faults (E plus a number or a letter): Switch the appliance off and on again. Re-set the programme. Press the START/ PAUSE button.

If the fault is displayed again, please contact the Customer Care De- partment and inform them of the fault code.

Problem	Possible cause	Remedy
	Mains plug not plugged in	Plug in mains plug. Check
	or fuse not working.	fuse.
Washing machine does	Door not closed properly.	Close door – there should be
		an audible click.
not work.
	START/PAUSE button was	Press START/PAUSE button
	not pressed for long
		for longer.
	enough.
Door cannot be closed.	Child safety device engaged.	Release child safety device.
When a button is	The selected function can-	Make another selection.
pressed, Err appears in	not be combined with the
the multi-display.	programme set.
E40 appears.
END display flashes 4x,	Door is not closed properly.	Close door properly. Start
at the same time an
		programme again.
acoustic signal sounds
4x.
E10 appears.	Tap turned off.	Turn the tap on.
END display flashes 1x,
	Filter in the screw connec-	Turn off the water tap. Un-
at the same time an
	tion of the inlet hose is	screw hose, take out filter
acoustic signal sounds
	blocked.	and clean it.
1x.
(Problems with water	Water tap is blocked with	Check the water tap and
inflow)	limescale or faulty.	have it repaired if necessary.

19