Problem

Possible cause

Remedy

E10 appears.

The tap is shut off.

Turn on the tap.

The END indicator is

 

Turn off the tap. Unscrew the

flashing once, and si-

The filter in the inlet hose

hose, remove the filter and

multaneously an acous-

screw connection is blocked.

tic signal is sounding

 

clean it.

 

 

once.

The tap is blocked by limes-

Check the tap and have it re-

(Problems with the wa-

cale or faulty.

paired, if necessary.

ter inflow.)

 

 

 

The transit packaging has

Removing the transit pack-

The washing machine

not been removed.

aging.

 

 

vibrates when operating

The screw feet not correctly

Adjust the feet as described

or is not stable.

in the installation and con-

 

adjusted.

 

nection instructions.

 

 

Washing has not been

Only a few large items of

Always load the drum as full

as possible. Mix large and

spun.

washing in the drum.

small items.

 

 

 

The inlet hose screw con-

Tighten the inlet hose.

 

nection is leaking.

 

 

 

The outlet hose is leaking.

Replace outlet hose.

Water is running out

The drain pump lid has not

Close the cover properly.

from under the washing

been closed properly.

 

machine.

 

 

Washing was caught in the

Load carefully next time you

 

 

door.

wash.

 

The emergency drain hose is

Screw on the emergency

 

leaking.

drain hose firmly.

The wash water is

 

Follow the manufacturer's

foaming a lot. At the

Probably too much deter-

instructions exactly when

end of the wash cycle

gent has been used.

measuring out detergent.

the spinning stops.

 

 

 

 

There is a kink in the outlet

Straighten the hose.

 

hose.

 

 

E20 appears.

The maximum pump height

Please contact your local

The END indicator is

of 1m has been exceeded.

Service Force Centre

flashing twice, and si-

 

Switch off the appliance.

multaneously an acous-

 

tic signal is sounding

 

Disconnect the power plug.

twice.

The drain pipe is blocked.

Clean the drain pump. Re-

(Problems with the wa-

 

move foreign bodies from

ter outflow.)

 

the pump housing.

 

For sink spigot connections:

Clean the spigot.

 

The spigot is blocked.

 

 

 

 

 

20

Page 20
Image 20
Electrolux LAVAMAT 64810 manual E10 appears Tap is shut off Turn on the tap END indicator is