What to do if…?
Troubleshooting by yourself
If, during operation, the dryer shows an error display (one or more displays flashing on the programme progress display), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. Reset programme. Press the START/PAUSE button.
If the error display is still shown, please contact your local Service Force Centre and inform about flashing displays.
Problem | Possible cause | Remedy | |
| Mains plug is not plugged in | Plug in at mains socket. Check | |
| or fuse is not working cor- | fuse in fuse box (domestic in- | |
| rectly. | stallation). | |
Dryer does not work. | Loading door is open. | Close loading door. | |
|
| ||
| Base door is open. | Close base door. | |
| Have you pressed the START/ | Press the START/PAUSE button | |
| PAUSE button? | again. | |
|
| Select a different programme | |
| Wrong programme selected. | the next time you dry | |
| (see “Overview of pro- | ||
|
| grammes” section). | |
| Lint filter clogged. | Clean lint filter. | |
| Heat exchanger clogged | Clean heat exchanger. | |
| with lint. | ||
|
| ||
|
|
| |
Drying results unsatis- | Overloading of laundry. | Observe recommended load- | |
ing volumes. | |||
factory. |
| ||
|
| ||
| Ventilation slots in base area | Uncover ventilation slots in | |
| covered up. | base area. | |
| Residue on inside surface of | Clean inside surface of drum | |
| drum or drum ribs. | and drum ribs. | |
| Conductance of water at in- | ||
| stallation site differs from | ting for degree of drying (see | |
| standard setting of ma- | ‘Programming options’ sec- | |
| chine. | tion). | |
Loading door does not | Fine strainer not in place | Install fine strainer and/or | |
and/or large mesh filter not | snap large mesh filter into | ||
close. | |||
locked in place. | place. | ||
| |||
|
|
|
20