Electrolux MCC 663 Connecting to the mains, Information concerning UK installation

Models: MCC 663

1 48
Download 48 pages 30.68 Kb
Page 6
Image 6

Connecting to the mains

The oven is delivered with the power cord and a plug for 230-240 V, 50Hz, earthed socket outlet.

Earth protection minimizes the risks should a short-circuit occur. Check to ensure the voltage of the oven matches the supply. N.B. If the oven is connected to the socket via an extension cord,

make sure the cord is earthed.

This appliance must not be used on a non-earth protected power supply. Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.

Microwave power output : 900W

This appliance complies with E.E.C. directive No.87/308 of 2.6.87 relative to radio interference suppression.

Information concerning UK installation

If this appliance is fitted with a non-

rewirable plug for which your socket is

un-suitable, the plug should be cut off

and the appropriate plug fitted. If it is

necessary to change the fuse in a

non re-wirable plug, the fuse cover must

be refitted. If the fuse cover is lost or

damaged, the plug must not be used

until a re-placement is obtained.

The plug moulded on to the lead

incorporates a fuse. For replacement,

use a 13 Amp BS1362 fuse. Only ASTA

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

GREEN AND YELLOW

EARTH

BLUE

NEUTRAL

BROWN

LIVE

If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows:

Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter ‘E’or the earth

symbol ( ) or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with

the letter ‘N’or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter ‘L’ or coloured red.

GREEN & YELLOW

13 AMP FUSE

 

or BSI approved fuses should be used.

The plug must not be used if the fuse

cover/carrier is lost. The cover/carrier is

indicated by the coloured insert at the

base of the plug. A replacement cover /

carrier is indicated by the coloured

insert at the base of the plug and must

be obtained from your local Electrolux

Service Centre.

BLUE

BROWN

CORD

CLAMP

6

Page 6
Image 6
Electrolux MCC 663 instruction manual Connecting to the mains, Information concerning UK installation