ELECTRICAL CONNECTION
Any electrical work required to install this cooker should be carried out by a qualified electrician or comp etent person, in accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
This cooker is designed to be connected to a 240V, 50Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the cooker rating plate. The rating plate is located on the oven frame.
The cooker is supplied with a 3 core flexible supply cord incorporating a 13amp plug fitted. In the event of having to change the fuse, a 13amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason, the wires in the mains lead are coloured in accordance with the following code:
Green and Yellow | - Earth |
Blue | - Neutral |
Brown | - Live |
-Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow.
-Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black.
-Connect the brown (live) wire to the terminal in the plug which is marked with the letter 'L' or coloured red.
Upon completion there must be no cuts, or stray strands of wire present and the cable clamp must be secure over the outer sheath of the cable.
Fuse capacity: 13A
NOTE: The earth wire should be about 2 cm longer than the live and neutral wires.
Note:
Check on the rating plate the value for the total connection power for establishing the fuse power.
Before connecting check that:
•fuse and household electric installation can carry the load of the appliance (see rating plate);
•The plug used for connection is easily accessible when the appliance is installed.
Warning
It is forbidden to route the supply cable across the back of the oven.
Important
If the supply cable is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person to ensure safety.
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safety.
fig. 19
Permanent Connection
The electrical connection should be made using a double pole isolating switch (cooker control switch) with at least 3mm contact separation in all poles. The cable must have conductors of sufficiently high
The switch must not break the yellow and green earth cable at any point.
Ensure that the cooker supply cable does not come into contact with surfaces with temperatures higher than 50° C.
22
