9.CHECKING LID CUT-OFF DEVICE
1.Lift the lid.
2.Turn on and ignite hotplate burner.
3.Close lid. There should be no gas supply to the hotplate and the burner will go out.
4.Turn off the hotplate tap.
5.Lift the lid. The gas supply should now be restored to the hotplate when the tap is turned on.
10. CHECKING THE MAIN OVEN CONTROLS TO SET THE TIME OF DAY (see Fig.6)
1.Turn on the electricity supply and ensure that the thermostat is in the off position.
1a. Before setting timer read important note below.
2.Rotate the left hand clock knob to 'Manual' and back to the 'Clock' position.
3.Set the time of day by rotating the right hand knob. Note that it is a 24 hour clock.
4.Rotate the left hand clock knob back to the 'Manual' position.
Fig.6
NOTE: When setting the time of day with the selector knob in the 'Clock' position only, this will activate the timer for seven seconds after selection. This means that when setting the time of day in this function the time can only be set by using the right hand knob within a seven second period.
After seven seconds have elapsed from when the correct time of day has been set, the timer ceases to be active and subsequent operation of the right hand knob will not change the clock.
11. CHECKING THE MAIN OVEN
1.Set the clock as described above, the clock is now ready for manual operation.
2.Turn the oven thermostat knob to Mk 9 and press the ignition button. As soon as the burner is alight the button can be released.
3.There should now be a low gas rate to the burner, which is the F.S.D. by pass rate.
4.When the F.S.D. phial has heated up it opens the F.S.D. valve which allows the main gas supply to the oven burner.
5.After 1 minute check that the flame covers the full width of the burner and is stable.
6.Set the oven control to Mk 2, close the oven door and check that after about 10 minutes the flame size has reduced.
7.Turn off the control and check that the oven flames go out.
50
