20
Cleaning heat exchanger
If the HEAT EXCHANGER display is illuminated, the heat exchanger needs to
be cleaned.
Caution! Operating when the heat exchanger is clogged with lint can dama-
ge the dryer. This also increases energy consumption.
1.Open loading door
2.Open base door. To do this, press the
release button on the bottom of the
loading opening and open the door to
the left.
3.Remove lint from the inside of the door
and the heat exchange chamber. Wipe
the door seal with a damp cloth.
4. Turn both lock washers inwards.
5.Use the handle to pull the heat exchanger
out of the base and carry it horizontally to
prevent any remaining water from spilling.
6.To empty the heat exchanger, hold
vertically over a washing-up bowl.
Caution! Do not use sharp objects to
clean. The heat exchanger could
develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse
thoroughly with a shower head.
8. Replace heat exchanger and lock into
place (turn both lock washers
outwards until they snap into place).
9. Close base door.
The dryer will not operate if the HEAT EXCHANGER indicator is still lit.
Caution! Never operate the dryer without the heat exchanger.
125983990.qxp 2006-04-21 07:12 Page 20