Installation Instructions
Over the Range Microwave Oven
Before You Begin Read these instructions completely and carefully.
•IMPORTANT Save these instructions for local inspector’s use.
•IMPORTANT Observe all governing codes and coordinates.
•Note to Installer – Be sure to leave these instructions with the Consumer.
•Note to Consumer – Keep these instructions for future reference.
•Skill Level – Installation of this appliance requires basic mechanical and electrical skills.
•Proper installation is the responsibility of the installer.
•Product failure due to improper installation is not covered under the Warranty.
•Please read all instructions thoroughly before installing the Over the Range Microwave Oven. Two people are recommended to install this product.
•If a new electrical outlet is required, its installation should be completed by a qualified electrician before the Over the Range Microwave Oven is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2.
1 MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting space on a wall as shown in Figure 1. It is designed to be used with standard 12" wall cabinets.
12" |
|
|
|
| 30" |
| 15.5" |
|
| At least 2" | 30" or more |
Backsplash | from cooking | |
| surface | |
|
| |
|
| 66" or more |
|
| from floor |
|
| Figure 1 |
2 WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted against and supported by a flat vertical wall. The wall must be flat for proper installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2" x 4" wood studding and 3/8" or more thick dry wall or plaster/lath. The mounting surfaces must be capable of supporting weight of 110
The unit should be attached to a minimum of one 2" x 4" wall stud.
To find the location of the studs, one of the following methods may be used:
A.Use a stud finder, a magnetic device which locates the nails in the stud.
B.Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. The center of any adjacent studs will normally be 16" or 24" to either side of this mark.
Need Help?
For customers in the United States, call:
For customers in Canada, call:
Read Carefully. Keep These instructions.
P/N 316495006 | ||
TINSEB484MRR0 | ||
|
E
