Electrolux TINSEB504MRR0 dimensions Carpentry, Electrical Requirements, Cabinet Installation

MICROWAVE WALL OVEN INSTALLATION INSTRUCTIONS

Important Notes to	IMPORTANT SAFETY
the Installer	INSTRUCTIONS

1.Read all instructions contained in these installation instructions before installing the Microwave Wall Oven. This oven can be built into a cabinet or wall by itself or above any electric wall oven or warming drawer.

2.Remove all packing material from inside the oven cavity before connecting the electrical supply to the Microwave Wall Oven. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the cavity ceiling. See Figure 2A.

Waveguide Cover

Oven Cavity

Door Seals

and Sealing

Surfaces

Hinge

Safety Door Latch

Figure 2A Figure 2B

3.Remove the 2 shipping duct supports (see Figure 2B) by removing the 2 screws securing each side. Reinsert 2 screws (each side) to secure the stainless cover.

4.Remove the feature sticker, if there is one, from the outside of the door.

5.Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealling surfaces, broken or loose door hinges and latches and dent inside the cavity or on the door.

If there is any damage, do not operate the oven and contact your dealer or ELECTROLUX AUTHORIZED SERVICER.

6.Observe all governing codes and local ordinances.

7.Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your Owner's Guide for future reference.

Never use your appliance for warming or heating the room. Prolonged use of the oven without adequate ventilation can be dangerous.

Carpentry

Refer to Figure 1 for the dimensions required for your appliance, and the space necessary to install the oven. The oven support surface should be solid plywood or similar material, the surface must be level from side to side and from front to rear.

Electrical Requirements

The appliance operates on a 120 volt, 60 Hz electrical supply with a separate ground wire. Provide a separate circuit with a fuse or circuit breaker rated for 15 amps.

Observe all governing codes and local ordinances

To prevent damage to the oven control, during cold temperature weather, wait at least three (3) hours after receiving this oven before supplying power to the appliance. This will prevent possible damage to the built-in oven control at power on.

Cabinet Installation

The Microwave Wall Oven can tip when the door is open. The Anti-Tip brackets supplied with the Microwave Wall Oven must be attached to the cabinet and the appliance to prevent tipping of the unit and injury to persons.

Anti-tip Brackets Installation

Instructions

1.Unpack the Microwave Wall Oven and find the 2 Anti-Tip brackets and screws included in the literature package.

2.Install the Anti-Tip bracket in the cabinet as shown on Figure 3. Note: To prevent damage to cabinet, it is recommended to drill ¹/16" (0.16 cm) diameter pilot holes before installing the Anti-Tip brackets.

E2