SCRUBBING AND DRYING OPERATION
SCRUBBING AND DRYING OPERATION
Open the tank lid.
Fill the left tank with water to within about 75mm (3”) from the top edge then add the scrubbing detergent in a quantity to make a dilution according to its instruction.
Too strong a mix wastes detergent, too weak a mix will not work efficiently.
The machine is now ready for use so move off to the site to be cleaned.
Switch the machine on by turning the key in the
10
Unclip the recovery tank emptying hose and remove the drain plug whilst holding the pipe at its highest extent, then lower it carefully into a gully or drain.
Note:
It is against Water Regulations to discharge detergents into a surface drain, only use a foul gully or drain.
At the same time as emptying the recovery tank check if the clean tank requires refilling.
If the clean liquid runs out then it is recommended that to save time the recovery tank be emptied at the same time as the clean tank is refilled.
A switch is fitted on the rear panel to the right of the control handle which controls the drive motor power. With the switch lever in the up position the traction motor is disconnected and the machine may be pushed easily from site to site when the mains lead is unplugged or when the batteries are not available.
OFF |
ON |
15 |
