SCRUBBING AND DRYING OPERATION
SCRUBBING AND DRYING OPERATION
When the machine is ready for scrubbing select the estimated amount of clean liquid required by pressing the detergent flow control on/off push button; an indicator will light which can be increased in three steps for varying the quantity of liquid delivered to the brushes.
If more liquid is required press the boost pump on/off push button which will double the amount of flow; this will be shown by the indicator.
Note:
The liquid will be delivered to the brushes only when the machine is moving forward and the brushes are rotating. If either the brushes or the forward traction are stopped the liquid flow will stop.
Lower the squeegee to the floor.
Press the suction on/off push button.
Start the brushes rotating, move the machine slowly forward, then immediately lower the brushes to the floor by lifting the foot pedal. (If the brushes are allowed to rotate in contact with the floor without the machine moving then it is likely to cause “polo rings” on the floor).
Whilst moving forward observe the cleaning effect on the floor and adjust the detergent flow to the minimum required whilst being liquid enough to be picked up by the squeegee. This allows the liquid to last longer before having to refill the tank. If too little liquid is used the floor will dry with a “sludgy” grey look to it.
The height of the drive handle can be adjusted by turning the knob A.
The speed range can be selected by means of switch B.
Adjust the brush pressure to the minimum required; this will assist in using the least amount of power necessary from the battery which will then last longer before requiring recharge.
A |
B |
+ |
12
13
