Something not working 33

Problem

Possible cause/Solution

The machine fills then empties immediately:

The machine does not empty and/or does not spin:

There is water on the floor:

Unsatisfactory washing results:

The end of the drain hose is too low.

Refer to relevant paragraph in «water drainage» section.

The drain hose is squashed or kinked. E20

• Check the drain hose connection.

The drain pump is clogged. E20

• Clean the drain pump.

The option Rinse HOLD has been selected.

Disable the option Rinse HOLD.

Select the Drain or Spin programme.

The laundry is not evenly distributed in the drum.

• Redistribute the laundry.

Too much detergent or unsuitable detergent (creates too much foam) has been used.

• Reduce the detergent quantity or use another one.

Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.

• Check the water inlet hose connection.

The drain hose is damaged.

• Change it with a new one.

The cap on the emergency emptying hose has not been replaced after cleaning the pump.

Put the cap back on the emergency emptying and place the latter back in its seat.

Too little detergent or unsuitable detergent has been used.

• Increase the detergent quantity or use another one.

Stubborn stains have not been treated prior to washing.

Use commercial products to treat the stubborn stains.

The correct temperature was not selected.

• Check if you have selected the correct temperature.

Excessive laundry load.

• Introduce into the drum less laundry.

Page 33
Image 33
Electrolux WA L6 E100, WA L4 E100, WA L2 E100 user manual Something not working