7
DH 315
3. To align, fold infeed and outfeed table up and
set the two each backstop setting screws
(arrow) as required.
Cutter knife replacement
3Dull cutter knives are noticeable by
-reduced performance;
-increased risk of kickback;
-stalling of the motor.
ADanger!
Risk of cut by the cutter knives! Wear gloves
when changing cutter knives.
To remove the cutter knives:
1. Unplug power cable.
2. Fold outfeed table down.
3. Lower the cutterblock.
4. Unscrew and remove the cutterblock cover/dust
extraction adaptor respectively.
5. Turn cutterblock by hand (use gloves!) until the
lock bar is on top.
6. Unscrew the cutter knife lock bar screws.
The cutter knives are being pushed up by
springs when the screws are loosened.
7. Remove both cutter knife and lock bar.
8. Clean surfaces of cutterblock and lock bar.
ADanger!
Do not use cleaning agents (e.g. to remove
residue resin) that could harm the light metal
components; it could have an adverse effect
on the stability of the planer.
9. Place lock bar into cutterblock as illustrated.
10. Place fresh cutter knife into cutterblock as illus-
trated.