Elinchrom 19350 manual Troubleshooting, CE Statements

Troubleshooting

Should an error occur, first check the following points:

Having this problem?	Check the following points:
No flash unit can be triggered	 Check if the Transmitter is switched ON.
with the Transmitter	 Check battery polarity.
Mode “All” is selected	 Check if the Receiver module is connected correctly to the unit.
	 Check if the frequency selector switch is set to the same channel.
	 Check if Transmitter is in the same trigger mode Speed or
	Standard.
Some units do not fire when	 Check if the Channel selector switch is set to the same Group.
triggered with the Transmitter	 Reduce distance to any “not working” unit.
Mode “Grp” is selected	 Check if Transmitter is in the same trigger mode Speed / Standard.
TEST flash works, but the	 Check hot-shoe fitting.
camera will not trigger flash	 Connect the 2.5 mm to PC SYNC cable instead of hot-shoe
unit	connection.
Limited Distance range	 Reposition the units.
	 Increase the distance to walls and ceilings.
	 Position the antenna of Transmitter and Receiver.
	 Use an RX extension cable to reduce the distance between the
	modules.

CE Statements

This device has been tested and found to comply with the requirements set up in the council directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC

9