Elinchrom Ranger RX manual Wireless Remote Control and Flash Triggering, Synchronisation Socket

Wireless Remote Control and Flash Triggering

The charge socket is as well the interface for the EL-Skyport Trigger and Remote System. With the EL-Skyport RX Trigger Set 19362, the Ranger RX can be triggered wireless, up to approximatly 100 m distance. Apart from triggering, the Transmitter offers modelling lamp on/off settings and flash power control in 1/10th steps.

By using the EL-Skyport Computer Remote / Trigger Set 19361, all Ranger RX functions can be controlled and operated with a Mac° or Windows° computer.

Note :

To connect the Transceiver RX 19353, the Remote Adapter 19374 is required.

For details of the most advanced wireless system please visit :

www.elinchrom.com/products/RX Multi Remote/EL-Skyport

Synchronisation Socket (14)

Connect the Sync lead with the traditional EL-synchro socket 14.

To protect the synchronisation circuits of your camera, Elinchrom uses only 5 Vdc. Use only Elinchrom synchro leads, code: 11075.

Charge Socket and Remote control (15)

To charge the Battery, use only the Elinchrom charger Code 19293.

The Ranger RX offers two charging possibilities: Connect the EL charger to the charge socket 15, or to recharge the battery externally, release the Battery Box, and connect the charger to the charge socket on the Battery Box.

How to change the Battery Box:

1.Place the Ranger RX pack on a flat and clean surface.

2.Press simultaneously the two push buttons (on each side of the Ranger RX pack).

3.Lift up the Ranger RX pack approx 5 cm and keep pressing the push buttons.

4.The Battery Box slides out by its own weight.

5.Place the new, charged Battery Box on a clean surface.

6.Place the Ranger RX housing over the Battery Box.

7.The Battery Box locates inside the Ranger RX housing.

8.Press down on top of the Ranger RX pack to activate the locking mechanism.

9.Check, that the Battery Box is secure inside the unit!

Push button 9