Elitegroup TRW-1 Wiring Instructions, REV.1/25/05 Page 5 of 9, Hearth Mount

To attach wall cover plate to receiver box:

1.Position the receiver as shown in diagram to the left with lower tab on wall cover plate into groove of receiver (Make sure ADJ hole

and LEARN hole on cover plate properly aligns with remote receiver)

2.Pull receiver up and snap into top tab of cover plate.

3.Position the wall cover plate so the word ON is facing up.

4.Install the remote receiver into the plastic switch box using the two long screws provided. Push the slide Button over the receiver slide switch only after making sure the remote receiver has LEARNED the transmitter’s security code (see MATCHING SECURITY CODES). NOTE: slide button covers both ADJ and Learn holes when properly installed.

Cover Plate

(Rear View)

Remote Receiver

					WALL
Receiver		LEARN	ON	LEARN	ON
			E
			R		REMOTE
Slide			O
Button			E
			M
			T
	ADJ.		OFF	ADJ.	OFF
				Remote Receiver
	Cover Plate				Plastic Switch Box

NOTE: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is in the REMOTE position. If the system does not respond to the battery transmitter on initial use, see MATCHING SECURITY CODES, and recheck battery positions in the remote receiver.

HEARTH MOUNT

MILLIVOLT

VALVE

Remote Receiver

ADJ.

		LEARN
OFF	REMOTE	ON
Frequency adjusting		Learning
access hole		button

The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the control access panel. Position where the ambient temperature inside the receiver case does not exceed 1300 F.

NOTE: Black Slide Button is used for Hearth Mount applications.

WIRING INSTRUCTIONS

A qualified electrician or a gas technician who is familiar with the gas appliance and gas valves that will be operated by this remote should install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or electronic module operating the gas appliance and may also damage the remote receiver.

WIRING MILLIVOLT VALVES

The remote receiver is connected to the millivolt valve using the TH (thermostat) terminals on the terminal block on the millivolt gas valve. Connect 18 gauge stranded or solid wires from the remote receiver to the gas valve.

Operation of the remote receiver is similar to that of a thermostat in that both turn the gas valve on and off based on input signals. A thermostat’s input signals are different temperatures. The remote receiver’s input signals come from the transmitter.

Connect each of the two wires leading from the TH and TH/TP terminals on the millivolt gas valve to either of the two wire terminals on the remote receiver. Normally it does not matter which wires go to which terminal.

REV.1/25/05 Page 5 of 9 Part #17810