31
C
HAPTER
4
R

EGULATORY

I

NFORMATION

Electrical Safety Info r mation

A) Complianc e is required with respect to the voltage , frequency, and current
requirements indicated on the manufacturer’s label. Connection to a different
power source tha n those specified herein will likely result in improper operation or
damage to the equi pment, or may pose a fire hazard if the limitations are exceeded.
B) There are no operator serviceable parts inside this equipment. This equipment
generates h azardous volt ages that c onstitute a safety haz ard. Servi ce should be
provided only by a qualified service technician.
C) This equipment is provided with a detachable power cord that has an integral
safety ground wire and three-prong connector intended for connection to a
grounded safety outl et.
1) Do not s ubstitute th e cord with a ny cord othe r than the pr ov id ed approved
type. Under no circumstances use an adapter plug to connect to a two-wire
outlet, as this will defeat the continuity of the grounding wire.
2) This equipment requires the use of the ground wire as a part of its safety
certification. Modification or misuse can provide a shock hazard that can
result in se rious injury or death.
3) If there are any questions about the installation prior to connecting the
equipment to mains power, contact a qualified ele ctrician or the manufacturer.

Emissions and Immunity Information

A) Notice t o Users in the United States : This equipm ent has been t ested and fou nd
to comply w ith P ar t 15 Class B of FCC R u l es for digital devices. These lim its are
designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment gener ates, uses, and can radiate radio
frequency ener gy, and if not installed and used in accordance with the instructions,
may cause harmful inter ference to radio communications.
B) Notice to Users in Canada: This equipment has been tested and found to
comply with Class B radio noise em ission limits as establis hed by the Radio
Interference Regulations of Industrie Canada for digital devices.
C) Notice to Users in the European Union: This equipment has been tested and
found to comp ly with the C lass B requi rements o f CE markin g for Inform ation
Technology Equipment as required by: Low Voltage Directive 73/23/ECC and
standard EN 60950; EMC Directive 89/336/ECC, and per standard EN 55022.
D) General Information to All Users: This equipment generates, uses, and can
radiate radi o fre que ncy en er gy. If not in stal le d and used acc or din g to th is m anu al,
the equipment may cause interference with radio and television communications.
There is, however, no guarantee that interference will not occur in any particular
installation due to site-specific factors.