GB

•If an extension cord is used it must be suited to the power consumption of the appliance, otherwise overheating of the extension cord and/or plug may occur.

•This appliance is not suitable for commercial use nor for use in the open air.

•Never leave the appliance unattended while it is in use.

•Children cannot recognise the dangers involved in the incorrect use of electrical appliances. Therefore never allow children to use household appliances without supervision.

•Always remove the plug from the socket when the appliance is not in use and each time before it is cleaned.

•Danger! Nominal voltage is still present in the appliance as long as the appliance is connected to the mains socket.

•Switch the appliance off before disconnecting from the mains.

•Never use the cord to carry the appliance.

SPECIAL SECURITY ADVICE

Do not use hard utensils inside the cooler.

These might damage its coating.

Only use wooden or plastic (rubber) utensils.

•The cooler must not be heated.

•Do not operate the appliance when it is dry.

•The appliance is not suitable for dishwashers.

•Do not touch the cold cooler with wet hands. Danger of injury!

•Do not use alcohol to make ice cream as it impedes the freezing process.

•Do not pour sugar directly into the appliance. Always dissolve it first.

PRIOR TO FIRST USE

•Remove all packaging material.

•Clean the appliance as described in Cleaning and care.

OPERATION

Unlock the lid (7) with the motor unit (2) by turning it counter-clockwise.

Remove upwards.

•Cool down the cooler (4) in a freezer or an ice box. The cooling temperature should be at least -18 °C. Place the cooler in the rear of the freezer. The cooler should be cooled for at least 12 hours.

The time may vary according to the amount of ice cream you want to prepare.

•Remove the cooler from the freezer or from the icebox. Place it on a stable surface.

•Never touch the cooler with wet hands.

•Attach the mixer (5) to the drive shaft (8).

Then, place the lid with the attached motor unit and mixer onto the cooler and tighten it by turning it clockwise. Observe the locking grooves while doing this.

•Connect the power plug (3) with an outlet. Switch on the appliance with the on/off switch I/0 (1). The motor starts running. The mixer is turning.

•Pour the prepared ice cream mixture slowly through the fill orifice (6) into the cooler.

•Leave the appliance switched on for about 20 to 40 minutes. The ice cream takes shape inside the cooler.

•Switch off the appliance with the on/off switch I/0. Disconnect the power plug from the outlet.

•Unlock lid and motor unit by turning it counter-clockwise. Remove upwards.

•Remove the finished ice cream with a wooden or plastic spatula out of the cooler. Do not use metallic utensils.

•The ice cream maker produces soft ice cream.

If you want to make harder ice cream, place the cooler for a maximum of 20 minutes in the freezer or place the ice cream in other suitable containers.

These containers can be cooled for longer periods of time.

7

GB

RECIPES

•Create the mixtures in separate containers, not in the cooler.

•If you want to produce smaller/larger quantities of ice cream than mentioned in these recipes, you may decrease/increase proportionally the quantities of the required ingredients.

•Use caution when using raw eggs. Only use fresh eggs.

Fiordilatte ice cream 1 egg yolk

60 g sugar

100 ml milk

100 ml cream (not whipped) a few drops of vanilla extract

•Mix egg yolk and sugar in a bowl until it is foamy and brightly-coloured.

•Stir in cream and milk. Mix all ingredients well.

•Pour the mixture into the ice cream maker.

Chocolate ice cream 1 egg yolk

60 g household sugar

15 g cacao

220 ml milk

a few drops of vanilla extract a pinch of salt

•Mix egg yolk and sugar in a bowl until it is foamy and brightly-coloured.

•Continue to stir the mixture. Simultaneously, add cacao, milk, sugar, a few drops of vanilla extract and a pinch of salt.

•Mix well all ingredients.

•Pour the mixture into the ice cream maker.

Vanilla ice cream 1 egg yolk

60 g sugar

160 ml milk

60 ml cream

a few drops of vanilla extract

•Mix egg yolk and sugar in a bowl until it is foamy and brightly-coloured.

•Rinse a heavy pot with water. Afterwards, while continuously stirring, heat up the milk until it almost comes to the boil. Then, remove the pot from the stove. Slowly add the mixture of sugar and egg, while continuously stirring.

•Place the pot on the stove again. Heat it up a little until the mixture thickens. When that has happened, remove the pot immediately from the stove. Do not heat up the mixture any longer.

•Let the mixture cool, until it reaches room temperature. Then, stir well while adding the cream.

•Pour the mixture into the ice cream maker.

Stracciatella ice cream 120 ml milk

60 ml cream

30 g dark chocolate

30 g sugar

a few drops of vanilla extract a pinch of salt

•Mix milk, cream, sugar, vanilla extract and salt.

•Pour the mixture into the ice cream maker. Add little chocolate crumbs as soon as the mixture starts to become more voluminous

8

Page 4 Page 6
Page 5
Image 5
Elta SE101 instruction manual Special Security Advice, Prior to First USE, Operation, Recipes
Page 4 Page 6

SE101 specifications

The Elta SE101 is a highly advanced unmanned aerial vehicle (UAV) that has garnered attention for its sophisticated capabilities and robust design. Developed for a variety of applications, including surveillance, reconnaissance, and border patrol, the SE101 is an exemplary model of modern aeronautical engineering.

One of the standout features of the Elta SE101 is its long endurance capability. With a flight time exceeding 20 hours, this UAV enables extended missions without the need for frequent refueling or battery replacements. This attribute is particularly beneficial for military and security operations where long-term monitoring is crucial.

The SE101 is powered by a hybrid propulsion system that maximizes efficiency and performance. This system combines a quiet electric motor for low-noise operations with a gas engine for enhanced range and payload capacity. As a result, the UAV can operate in diverse environments, from urban areas to remote locations, making it a versatile platform for various scenarios.

Another key technology integrated into the Elta SE101 is its advanced avionics suite, which includes an integrated flight control system and a state-of-the-art navigation system. These features allow for precise automated flight paths, ensuring that the UAV can autonomously navigate complex terrains while maintaining optimal safety.

The SE101 is equipped with a suite of sophisticated sensors and payload options, including high-resolution electro-optical and infrared cameras. These capabilities enable real-time video streaming and data collection, allowing operators to conduct surveillance and reconnaissance missions with unparalleled detail. The UAV can also be outfitted with signals intelligence (SIGINT) and electronic warfare systems, further expanding its operational capabilities.

Built with rugged materials, the Elta SE101 is designed to withstand harsh weather conditions and environmental challenges. It incorporates features such as modular construction and easy maintainability, making it suitable for operation in dynamic situations. Furthermore, its stealthy design minimizes radar cross-section, enhancing its survivability in contested environments.

In summary, the Elta SE101 represents a significant advancement in UAV technology, offering long endurance, hybrid propulsion, advanced avionics, and diverse payload options. Its robust design combined with cutting-edge capabilities makes it an invaluable asset for military, law enforcement, and other security agencies around the world. The SE101 is a testament to the ongoing evolution of unmanned systems, providing users with the tools necessary for modern challenges.
Top Page Image Contents